OPERATING YOUR MEDIS 24-7 POWER PACK

HOW TO USE
To begin using the 24-7 Power Pack, follow these simple steps:
1. Read safety instructions before using Power Pack.
2. Remove the safety tape by twisting the green tab to tear the tape & pull it off.
Note: Remove safety tape ONLY when ready to activate the Power Pack.
3. FIRMLY squeeze the Power Pack to activate it. It is normal that this will require some force. Continue squeezing until FULLY compressed. The product is fully activated when there is no gap remaining in the section previously covered by the safety tape. You will hear clicking noises during activation – this is normal.
4. Give the Power Pack agentle shake and lightly tap on a hard surface to assure liquids are completely dispersed.
5. Insert the flat connector plug of the electrical cord into the slot of the Power Pack. Make sure to insert the plug with electrical contacts facing the Power Pack.
6. Insert the other end of the connector cable into the charging interface of your device using one of the provided connectors. You can confirm the Power Pack is functioning correctly by the indicator light on the cable plug and by the charge indicator on your device.
Note: The order of connection is important. For the Power Pack to work with your device properly, the cable must be connected to the Power Pack first and your device second.
Note: It can take up to 60 seconds before the indicator light is activated
and for your electronic device to show that it is receiving power. Your
24-7 Power Pack is now powering your cell phone/ electronic device for immediate and continued use.
Note for iPod and Sony Ericsson Users: To connect your device:
(1) connect the cable to the Power Pack, (2) put device tip into your
device and, (3) connect the other end of the cable into your device’s tip.

CLICK HERE to download complete instructions.